Search:

Type: Posts; User: lancialulu

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Re: Wanted: Lancia Fulvia HF e tutte le altre Fulvia book

    https://www.amazon.co.uk/gp/offer-listing/8879110845/ref=tmm_pap_new_olp_sr?ie=UTF8&condition=new&qid=&sr=

    Pricey though.
  2. Re: A question for those of you who know about electric motors

    I would have expected less volts due to the current draw of the motor. Its not drawing any current ........
  3. Replies
    7
    Views
    280

    Re: Rosa Mirabello?

    Bronzo Ascot
  4. Re: Gold Fulvia Wheel Cromadora Campagnola paint code

    Thanks Ed.

    I am on the case, but if anyone else has a match please chip in.

    Tim
  5. Re: Gold Fulvia Wheel Cromadora Campagnola paint code

    Ed I am not looking for definitive, just what folk have had as a good match/happy with....
  6. Replies
    16
    Views
    315

    Re: Removing S2 lower wishbones

    The Lancia Motor Club Has this tool for hire....
  7. Replies
    16
    Views
    315

    Re: Removing S2 lower wishbones

    I think the ball joint had a serated edge and was a bit of a push fit and over years has rusted in. I think you need to get the wishbone off with the ball joint to attack with a big hammer....
  8. Thread: Going nuts

    by lancialulu
    Replies
    15
    Views
    434

    Re: Going nuts

    I dont believe the nylon does anything other than hold the nuton the thread so it does not vibrate off *(as someone else said)... I have had no problems (touch wood) and have reused nylocks until...
  9. Replies
    26
    Views
    1,097

    Re: Synthetic gearbox oils in the USA

    Look at the magnetic drain plugs - grey mush is ok but chunks of steel is not....
  10. Gold Fulvia Wheel Cromadora Campagnola paint code

    Any ideas on this. Huh?

    The colour code I have is oro metallize DuPont 847-95991 but I can't cross reference it.
  11. Replies
    7
    Views
    280

    Re: Rosa Mirabello?

    Fulvia Coupes were painted in Longehamps Bronzo but this is a light almost gold colour.

    All the Sport Zagato paint codes

    DP= DuPont
    LS: Lesonal
    MM= Max Meyer

    Argento Nevada (metallizzato)...
  12. Replies
    7
    Views
    280

    Re: Rosa Mirabello?

    Hi Steve
    Nice project!
    A couple of points.
    Lancia supplied the chassis the Zagato and I believe these were always satin black, so anything under the engine bay black paint is a bit of a mystery....
  13. Replies
    26
    Views
    1,097

    Re: Synthetic gearbox oils in the USA

    But the box only has one filler point - where the dipstick is.
  14. Replies
    10
    Views
    294

    Re: 50th anniversary restoration

    Ed ( I know this has been discussed before but cannot find it) What is the code for the gold wheel colour. The Roin is in my opinion to red compared to earlier gold Fulvia campagnolas?
  15. Re: A question for those of you who know about electric motors

    Is it running in correct direction .i.e. have you swopped the + and - over by mistake?
  16. Re: What tyres? S2 1600 Zagato on 6" Cromadoras

    I run 165 80 14 on 6 j cromodoras on my 1600 sport no problem. It is the size specified for the 1600 sport. 175 14 80 may give minor clearance issues and over gear the car.
  17. Replies
    9
    Views
    451

    Re: Front wheel drive!?

    Looked up caster 1.3 Coupe = 2.5 deg, 1.6 Coupe 3.5 (This probably adds to the 1.6 steering heaviness). These are not wild figures.....

    The car is so stable due in part for having such a weight...
  18. Replies
    9
    Views
    451

    Re: Front wheel drive!?

    Michael

    Is your car a 1.3?? From your avatar photo I think it is.

    There are differences in 1.3 and 1.6 front suspension geometry to do with camber but both models have the unequal wishbone set...
  19. Replies
    5
    Views
    211

    Re: fuel pressure regulator, and fast idle

    Could be a small air leak on the manifold(s), or the sync screw has gone out of adjustment... , Does it drop if you manually pull the throttle lever harder back (I run a second spring which does not...
  20. Replies
    8
    Views
    257

    Re: Dismantling Seat Adjusters

    I believe you have to take out a large rivet..... Omicron dismantle them I think to correct the failure mode in the Sport hinge when the seat inadvertently collapses.... Not cheap though.
  21. Replies
    7
    Views
    228

    Re: Ultrasonic cleaner size

    I was leaning towards the 10 litre to get the depth but open to any other experience.
  22. Replies
    7
    Views
    228

    Ultrasonic cleaner size

    Thinking of investing in one but wondered what is the best size for automotive parts cleaning such as carburettors??

    Any experience?
  23. Replies
    4
    Views
    294

    Re: Interesting air box

    Thats a better idea as that lot must weigh the same as the battery which has been relocated....
  24. Replies
    12
    Views
    427

    Re: Accelerator Pedal Rollers?

    19mm diameter is too wide I think.....
  25. Replies
    12
    Views
    427

    Re: Accelerator Pedal Rollers?

    better to replace with roller bearings but cannot remember the size.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4