Zagato front seats

[spyder]

I have finally got around to doing something with my Zagato that I purchased at Christmas.

The car currently has no seats.
I intend to fit bucket seats eventually but I need to fit a seat to the drivers side for MOT

Will normal Fulvia coupe seats fit, or are they too wide?

[philm]

They should fit.

[spyder]

NICK G has lent me a standard 1.3 fulvia coupe seat.
I have checked the width measurements across the front of the seat runners and it measures hole to hole approx 500mm.

Checking the threaded holes in the floor of the Zagato the width from hole to hole across front of seat position is only about 350MM

Is this normal for a Zagato or have the seat frame mountings in the car been welded into the floorplan in a different position to original?

Appreciate any help from a Fulvia Zagato owner

[philm]

Cannot comment on the dimensions without measuring my cars, BUT I have plenty of Zagato seats if you need to borrow one or more for your MOT:cheers:

[Old Man Wattsy]

Humm. The centres to centre distance of the seat rails of my Series 2 Zagato is 384mm.

[spyder]

Thanks Guys for your help on this one. I will double check the distance between holes again on the Zagato floor pan

[philm]

380 on mine

[1,6 HF]

sounds like typical Zagato quality control...