Jim Keller
10th November 2009, 04:40 PM
Make me an offer, just a few little things I have left that need a home not the trash can.
Seat stuff: capture nuts and bolts for the front seats, I have stripped these easily so I save all I come accross, you get every thing in the picture including the seat carpet spacers
Distributor stuff for cam end drive distributor, full set of dist. clamping washers, one protective dust cap for under the rotor to protect the coil pickup from carbon tracks and shorting, one coil pickup, used, good for backup on trips or get ya going cheap, works, wires good, came from my old Coupe and worked fine but has small bit of odd wear on top of center hole from broken bushings below but will still be fine in a car, I didn't re-use as I had a new one when I rebuilt my distributor. Also includes cap retainer clips and hardware and a brand new bottom bushing that I had 10 of custom made years ago when I was rebuilding them for others, it's my last one and NOT available from vendors, plus anything else in the picture dist. related
4 fuel injection intake studs and 2 exhaust studs with nuts, these were new I bought for an engine I did that only covered 200 miles before the car and head was destroyed I salvaged
Set of head bolts and washers, same story as intake/exhaust studs, only in motor about 200 miles, torqued twice, they will be fine for any rebuild
Excelent set of Beta "Coupe" tail light lenses, almost new condition, with one chrome trim piece in very good but not perfect condition, chrome looks great till you get about two to three "inches" away, then you can see slight spotting in the chrome, may polish out
Box of odd ball hardware, look close, lots of impossible to find stuff there
Wiper assembly nuts and plastice trim nut covers
Set of very good hood latches
Set of rear suspension bolts in very good condition
Set of catylitic converter flex joint clamping springs, two with good studs and nuts
Radio mounting plate
Beta lower radiator plastic fan shrowd for fuel injected radiator
Beta door water curtin retainers
Beta front grill tab plastic valance inserts
Beta center console heater vent
Beta shift bushing balls, no bushings and one small adjustment link bushing for transmission mounting location missing one side of flange
What ever else may be pictured, buy it all or just sections as pictured, first come first served. Be quick on anything you want because If I do not reply to your email, PM me as my wife, thru Face Book and other poor judgement actions has put our family in a dangerous situation I wont' go into which may require me to temporarily cut off the online services for my childrens safety until this current situation is resolved, I will either use my parents computer to check in here from time to time or call me direct at 740-465-5700
Seat stuff: capture nuts and bolts for the front seats, I have stripped these easily so I save all I come accross, you get every thing in the picture including the seat carpet spacers
Distributor stuff for cam end drive distributor, full set of dist. clamping washers, one protective dust cap for under the rotor to protect the coil pickup from carbon tracks and shorting, one coil pickup, used, good for backup on trips or get ya going cheap, works, wires good, came from my old Coupe and worked fine but has small bit of odd wear on top of center hole from broken bushings below but will still be fine in a car, I didn't re-use as I had a new one when I rebuilt my distributor. Also includes cap retainer clips and hardware and a brand new bottom bushing that I had 10 of custom made years ago when I was rebuilding them for others, it's my last one and NOT available from vendors, plus anything else in the picture dist. related
4 fuel injection intake studs and 2 exhaust studs with nuts, these were new I bought for an engine I did that only covered 200 miles before the car and head was destroyed I salvaged
Set of head bolts and washers, same story as intake/exhaust studs, only in motor about 200 miles, torqued twice, they will be fine for any rebuild
Excelent set of Beta "Coupe" tail light lenses, almost new condition, with one chrome trim piece in very good but not perfect condition, chrome looks great till you get about two to three "inches" away, then you can see slight spotting in the chrome, may polish out
Box of odd ball hardware, look close, lots of impossible to find stuff there
Wiper assembly nuts and plastice trim nut covers
Set of very good hood latches
Set of rear suspension bolts in very good condition
Set of catylitic converter flex joint clamping springs, two with good studs and nuts
Radio mounting plate
Beta lower radiator plastic fan shrowd for fuel injected radiator
Beta door water curtin retainers
Beta front grill tab plastic valance inserts
Beta center console heater vent
Beta shift bushing balls, no bushings and one small adjustment link bushing for transmission mounting location missing one side of flange
What ever else may be pictured, buy it all or just sections as pictured, first come first served. Be quick on anything you want because If I do not reply to your email, PM me as my wife, thru Face Book and other poor judgement actions has put our family in a dangerous situation I wont' go into which may require me to temporarily cut off the online services for my childrens safety until this current situation is resolved, I will either use my parents computer to check in here from time to time or call me direct at 740-465-5700