More on A-arm removal

[KeppelmanJ]

I need to get to the a-arm pivot, rear, left side, to loosen and remove that pivot bolt. If I loosen and slide the two part anti-roll bar bushing assembly outward and off its sub-frame stub to get to that nut will I be able to slide it on again? Thanks.....

[HFStuart]

How have you got the car supported ? I've always found that with the suspension in full droop I could get a spanner on past that bush.

In any case yes i the answer - in fact I suspect you'll find it much easier than getting it off in the first place !

Stuart

[KeppelmanJ]

Thanks, Stuart. I find that having both anti-roll bar ends loose at the outboard clamps makes it all easier coming apart. I'm proceeding...