PDA

View Full Version : Message for Sprintcarfan


monster monte
11th April 2008, 02:40 PM
Hi John, Could you help? V6 Alfa engine on Meggasquirt ignition settings? Getting desperate!! Cheers, Paul (Monstermonte)
sprintcarfan
11th April 2008, 09:36 PM
Sent you a PM.
monster monte
12th April 2008, 07:52 AM
Top Man!!! Cheers Martin
sprintcarfan
14th April 2008, 09:32 AM
Have you had a chance to try out the settings yet?
monster monte
18th April 2008, 06:21 PM
Hi John, Chap you have saved my meggasquirt from taking to the skies!! It now runs!!! also found that as I was running VE1 table (have you kept Alfa loom?) it would only run 4,5,6 cylinders needed to import fuel settings to VE2 too so now it runs all cylinders as I have made new loom with "banked" injector wires so they are running alternating. I need now to re-change oil (only done in March this year) as it's full of fuel! Looking promising!! Thanks again Regards,Paul
sprintcarfan
25th April 2008, 05:39 PM
Hi John, Chap you have saved my meggasquirt from taking to the skies!! It now runs!!! also found that as I was running VE1 table (have you kept Alfa loom?) it would only run 4,5,6 cylinders needed to import fuel settings to VE2 too so now it runs all cylinders as I have made new loom with "banked" injector wires so they are running alternating. I need now to re-change oil (only done in March this year) as it's full of fuel! Looking promising!! Thanks again Regards,Paul

I didn't keep the loom, but I did have mine setup to run banked. I thought I had mine setup to run on one table only (VE1), though. No need to run two tables unless you have an O2 sensor in both banks.