rosssomerville
24th January 2008, 07:40 AM
I have had a short circuit on my beta 2000ie. The grey 2.5 mm wire from the fuse box connector at the end on the drivers side has melted. This is because that now I have replaced all the earth points and spade connectors the wire has been put back to where it was before but shouldnt have been and has shorted.
So where should the grey wire go? There are two grey wires coming out to the drivers side front headlamp corner. One grey wire should be for the head lamp and the other?
Also I would like to check where the wires are placed on the connector block to the fuse box so I can rewire the block and check it is correct without any doubt before I fry the thing again. Can somebody take a photo of their fuse box ,the far right connector block showing the wires and also the wiring in the front right drivers side corner. This will be rewarded somehow, ive got a lot of spare parts to trade.
Many Thanks.
My email is rs@flagtrader.co.uk
So where should the grey wire go? There are two grey wires coming out to the drivers side front headlamp corner. One grey wire should be for the head lamp and the other?
Also I would like to check where the wires are placed on the connector block to the fuse box so I can rewire the block and check it is correct without any doubt before I fry the thing again. Can somebody take a photo of their fuse box ,the far right connector block showing the wires and also the wiring in the front right drivers side corner. This will be rewarded somehow, ive got a lot of spare parts to trade.
Many Thanks.
My email is rs@flagtrader.co.uk