Activity Stream

thank you this looks to be a reasonable addition that will hopefully eliminate future issues.....at least in this realm.

Thank you for the input. I will look into adding this to the system

Switch should arrive soon, we will see how/ if that is the culprit

Bosch used to offer a (starter) relay kit: WR-1. $35. Or you can cobble one together yourself. Unloading the ignition switch amp-wise helps...

Stock would have been a 30/32 DHTA, so a 32 DHTA is a (slight) improvement if it's also on an 1800 manifold. The '79-only stock manifold can't make...

I had a similar issue with my Zagato. I added a relay to the starting circuit. It unloads the amperage that flows through the ignition switch. I...

Ignition switch is a good purchase. Verify all connections. If it clicks and doesn't crank, it could men the connections or ignition switch are good...

Tim Great to hear Your confirmation that you are troublefree regards pinking With V-Power fuels in Your HFs. You know its easy to overstretch it a...

I run Shell V power but not sure its 98 in the UK but think it is 97. I understand it is free currently of ethanol so it is good to hear this may...

Yes Bart I plan to use Shell V-Power 98 octane fuel. Still readily available at gas stations here in Norway. It is also complete free of ethanol....

Dear Todd, This is why I love this Forum! Thank you and I'll be back on the road in no time now!! Jay

To take a front subframe bolt out ,you will need a 22mm socket. The bolt is an M-14 with a 1.5mm thread. From the head to the tip its 80mm long...

For those of you intent on using 5.5 x 14 wheels: a set of Flavia CD34 has just been put online for sale at German "Ebay Kleinanzeigen" (classified...

Very good. With 11.3 you will definitely need high octane >98 fuel. I went back to 10.8 and can (just) run 95 without the engine pinking too much....

I always recommend fitting a second return spring to the butterfly lever. Not noticeable on the pedal end but closes the butterflies for sure...

Yes, Rodger. Sold to Jason Greenwood in FL. Last I heard from Jason the moulds were unusable as they hadn't really been maintained very well. ...

Bart Rockers are original 1,3 HF as lightened and polished by the guys at Lancia in 1967. Indeed Nice craftmanship. I had them regrinded and...

I assume you are talking about Rodger Grantham. I managed to get an 037 rear bumper from him before he sold the molds to a guy in Florida I seem to...

Now found a pair of Roller Bearings for the throttle pedal on my Fulvia Ser 3 RS Components Miniature Ball Bearing 7mm I.D, 22mm O.D Stock...

Nice work. Noticed some holes on the head gasket didn’t match up. Is that a problem, or are the head gaskets generic for several variants? Just...

Excelent! Nice rockers! What is your CR?

Engine is coming together, finally.

Hi, It is the Front right (passenger side) Thanks!

Sounds like a good plan you have. There were less than 2000 Scorpions imported in total, so last 4 digits of the VIN will give you what number you...